Sonifex LD-40F2ONA-MCL Twin Flush Mounting 2x20cm ON AIR - MIC LIVE Sign
The SignalLED range of illuminated
RGB LED signs are a new range
of signs designed for installers.
Because the sign itself contains the
control electronics, and RGB LEDs
are used, the signs can be simply
configured onsite for your particular
requirements.
RGB LEDs - Any Colours Possible
The illuminating LEDs in the unit are RGB
meaning that any colour can be produced.
For ease of use, as standard you can
configure the sign from one of 6 colours:
white, green, red, blue, yellow & orange.
Dual Control Inputs
The sign can be controlled by either, or
both, of 2 pull-low inputs, e.g. a single input
can be used to control a single `MIC LIVE'
sign, or 2 inputs can be used to control a
twin `TX' and `REH' sign with independent
control of each side of the sign.
Different Display Modes
Four modes of illumination are available:
- Constant illumination.
- Flashing, regularly on/off.
- Pulsing - flashing, then off, repeated
- Off
Simple Installation
The signs are supplied with a 6V wall-wart
power supply & lead. Simply wire up your
control signal(s) and DC input to the `screw
terminal block' inside the sign, route the
cables through the integral cable clamp and
mount the unit on the wall.
The display mode and colour options are
set-up using an 8 way DIP switch, accessible
after installation.
Physical Specification
- Power Input: 5-7V DC
- 40cm Sign: 500mA max
- Input Connector: 4 way screw terminal block
- Control Inputs: 2 x pull-down to 0V
- Dimensions:: 40cm (W) x 8cm (H)
