Get the Best of Both Worlds...DUAL MONO OR STEREO
The 320D converts between acting as two independent mono processors and one linked stereo processor by front panel selection. This is true with both analog and digital I/O.ANALOG or DIGITAL IN, ANALOG and DIGITAL OUT !
The 320D serves as a fine A to D converter with processing. When you use the analog input, the digital output contains the Compellor's processing and is therefore ready for use in almost any application. Conversely, the 320D serves as a fine D to A converter. When you use the digital input, the analog output contains the Compellor's processing, and is properly levelled and packaged.ANALOG AND DIGITAL AUDIO INTERFACES
The professional analog audio inputs and outputs are fully balanced and adapt to consumer or professional operating levels at the touch of a button. Analog or digital source selection is made at the rear panel. For digital interfacing, the 320D contains a high quality 24 bit low noise codec to receive digital audio and transmit digital audio. Once the incoming digital audio is converted by the DAC section, it passes through the compellor as normal audio. The audio output is then converted back to digital by the ADC section of the codec.The rear panel AES3 jacks are standard professional 110 ohm interfaces. There is no word clock input or output. Synchronizing is done from the AES3 input signal or an internal clock. When a digital input is present, the output is synchronized to the input sample rate. If no digital input is present, the digital output automatically locks to the internal default sample clock. The user can specify the sample rate by changing the internal crystal. Spare crystals for 32kHz, 44.1kHz, 48kHz, and 96kHz are supplied with the unit free of charge. The model 320D codec translates the -20dBfs level of the digital audio source to the 0dB reference within the Compellor circuits. The average output levels will target around -20dBfs. The selectable peak limiter's threshold translates to -6dBfs. Thus, no digital audio output peaks will rise above -6dBfs when the limiter is on. The combination of averaging the level around -20dBfs and holding peaks below -6dBfs packages the audio perfectly for natural sound quality and for most transfer or transmission purposes. For example, the digital audio would be ready for direct input tone MP3 encoder, HD recorder, Broadcast digital STL, .wav file, etc.