SurgeX SU-1000Li Surge Eliminator/Power Conditioner Line Interactive 1000 VA UPS with Automatic Voltage Regulation

SurgeX SU-1000Li Surge Eliminator/Power Conditioner Line Interactive 1000 VA UPS with Automatic Voltage Regulation

Superior to standby UPS products, the SU-1000Li provides faster response, automatic voltage regulation, and battery backup during a brownout, blackout, surge, or power failure.

Unlike other UPS products, our SU-1000Li 1000 VA Line Interactive UPS is backed with SurgeX Advanced Series Mode patented surge elimination technology to shield computer and AV equipment from catastrophic damage. The SU-1000Li also includes common mode and normal mode Impedance Tolerant EMI/RFI filtering, and provides a sophisticated web browser-based interface to manage power settings, customize diagnostics, monitor multiple computers, and schedule shutdowns and restarts.

• Provides A-1-1 Certified fail safe protection from surges, spikes, blackouts, and brownouts.
  
  
• Automatic voltage regulation provides a stable AC source during less than optimal power conditions without constant use of internal batteries.
  
  
• Includes SentryPlus UPS power management and diagnostic software.
  
  
• Advanced Series Mode surge elimination technology stops all surges up to 6,000 volts without producing harmful side effects such as ground contamination or common-mode disturbances, is superior to conventional MOV and MOV-Hybrid circuitry, and is completely non-sacrificial.
  
  
• Over/Under Voltage Protection
  
  
• Credenza Friendly - Only 10.5" deep!

SurgeX SU-1000Li Features:

• 2U Rack Mount
• 1000 VA Battery Backup
• Advanced Series Mode Surge Elimination
• Impedance Tolerant EMI/RFI Filter
• Automatic Voltage Regulation
• Over/Under Voltage Protection
• SentryPlus Power Management and Diagnostic Software
• USB port
• Self-test Circuit and Visual Indicator
• Receptacles: 6 Surge Elimination, 2 UPS / 4 Non-UPS
• 10 Year Product Warranty
• 2 Year Battery Warranty
• A-1-1 Certified
• RoHS Compliant
• Made in U.S.A.

SurgeX SU-1000Li Specifications:

AC Input
• Number of Phases: Single (2W + G)
• Power Cord: 6-ft. grounded, 3 wire, #14 line cord
• Input Voltage (Acceptable Input Voltage): 120VAC (0 - 160VAC)
• Input Voltage Range (Normal mode): 90 - 150VAC
• DC Start Capability: Yes, (defaults to 60Hz)
• Power Requirements (no load): 35 watts (charging), 15 watts (charged)
  
  AC Output (Normal Mode)
• Load Rating: 15 Amps @ 120 volts
• Load Power Factor: 0.6
• Outlets: 6 outlets (15 Amp) all with Advanced Series Mode surge elimination, 2 outlets with battery back-up
• Output Frequency: Same as Input
• Short Circuit Protection: Re-settable circuit breaker and electronically limited
• Overload Capability: 110% - 5 minutes ?120% - immediate shutdown
• Output Voltage Regulation: 120VAC: -12.5% to +8.4%
• Waveform: Same as Input
• Boost Mode Voltage (Buck mode voltage): Nominal +16% (Nominal -14%)
• Line Mode Voltage Range: 105 - 130VAC
• Efficiency: Normal mode > 90%
  
  AC Output (Battery Mode)
• Capacity: 1000VA/600W
• Back-up Run Time: 4 minutes 600W full load, 10.4 minutes 300W half load
• Output voltage: Nominal 120VAC
• Waveform: Stepped sine wave (simulated sine wave)
• Topology: Single boost/buck line interactive, simulated sine wave
• Battery Mode Voltage Regulation: Nominal +- 6% until LBW
• Transfer Time: 6-10 ms
• Output Frequency & Regulation: 50/60Hz ñ 0.5Hz (Unless synchronized to utility)
• Short Circuit Protection: Active electronic (current limit)
  
  Batteries
• Battery Rating: (2) 12V/7AH
• Replacement: Hot swappable
• Recharge Time: 8 hours to 90% after full load discharge
  
  Surge Protection Specifications
• Surge Protection: Advanced Series Moder surge elimination
• Surge Energy Rating: 6,000 volts/3,000 amps
• Let through Voltage (6,000 volt surge): 0 volts
• UL 1449 Adjunct Classification Test Results: 1000 surges, 6000 volts, 3000 amps, B3 pulse; Measured suppressed voltage: 170 volts; no failures.
• Federal Guidelines: Grade A, Class 1, Mode 1 (CID A-A-55818)
• EMI/RFI Filter, Normal Mode (50-ohm load): 40 dB @ 100 kHz; 50 dB @ 300 kHz; 50 dB @ 3 MHz; 50 dB @ 30 MHz
• EMI/RFI Filter, Common Mode (50-ohm load): 18 dB @ 300 kHz; 30 dB @ 1 MHz; 50 dB @ 5 MHz; 50 dB @ 20 MHz
• Maximum Applied Surge Voltage: 6000 volts*
• Maximum Applied Surge Current: Unlimited, due to current limiting*
• Maximum Applied Surge Energy: Unlimited, due to current limiting*
• Endurance (C62.41-1991 Category B3 pulses): 1kV>500,000; 3 kV>10,000; 6 kV>1000
  
  General Specifications
• Warranty: (USA and Canada only) 10-year limited warranty
• Battery Warranty: 2 years
• Monitoring Software: Includes SentryPlus software
• Communications: USB
• Rack Size: 2U
• Unit Dimensions (H x W x D): 3.5" x 19.0" x 10.5"
• Unit Weight (lbs.): 32.0 lbs.
• Operating Temperature: 32øF to 104øF (up to 5,000 ft above sea level (0øC to +40øC (up to 1,500 meters above sea level)
• Operating Elevation: 32øF to 95øF (5,001-10,000 ft above sea level (0øC to +35øC (1,501 to 3,000 meters above sea level)
• Storage Temperature/Relative Humidity: 5øF to 113øF (-15øC to +45øC) / 0 - 95% non-condensing
• Humidity Range: 5% to 95% R.H., non-condensing
  
  * 1.2 x 50 pulse, industry standard combination wave surge, as per IEEE C62.41.

SentryPlus Power Management and Diagnostic Software

• Plan a schedule to shutdown, restart, test UPS and control receptacles
• Customize programmable actions
• Set up notifications of user-defined power related events via pager, e-mail, audible alarm, network broadcast and SNMP trap
• View Real-time UPS data meters (voltage, frequency, loading percentage)
• Analyze power history and event records via software data and graphs
• Configure Multi-computer shutdown/wakeup through TCP/IP network
• Access remote monitoring, control and configuration through TCP/IP network
• Monitor and network multiple UPSs at a glance in a LAN
• Communicate to UPS using Universal Serial Bus (USB)