Where to Buy Ashly Audio | Power Amps, Signal Processors

Viewing Item(s):

Display

Show As

Ashly Audio 24.24M Output - 4-Output Expansion Module for Protea 24.24M Matrix Processor
Item# ASH-2424M-OUT
The 24.24M Output from Ashley is a four-output expansion module for the Protea 24.24M Matrix Processor base unit. Each card provides an additional four channels of output and brings with it dedicated DSP and digital-to-analog converters. The card is field installable and require no additional programming from the base unit. Up to five output cards can be installed for a total of twenty-four outputs. Because of the on-board DSP, the base unit's processing is not impacted by the addition of...
Availability: Ships Factory Direct, Typically in 3-10 Business Days
Item Details
Ashly Audio CA-1.54 2RU 4-Channel High Efficiency Power Amplifier - 4x 1500 Watts @ 2/4 Ohms or 70V 750 Watts @ 8 Ohms
Item# ASH-CA-1-54
Ashly Audio CA-1.54 is a 2RU 4-Channel High Efficiency Power Amplifier with 4x 1500 Watts @ 2/4 Ohms or 70V 750 Watts @ 8 Ohms. Available in 2 & 4-channel configurations with 500W, 1,000W or 1,500W per channel, there's a CA that's right for your project. CA amps are designed to excel in Performance Installations, such as theaters, school auditoriums and Houses of Worship. Power-hungry sub-woofers? No problem. CA does 2 Ohms lying down. However, with 70 & 100V direct-drive capability and...
Availability: Usually Ships in 5-14 Days
Item Details
Ashly Audio mXa-1502 4-Zone DSP 16x4 Mixer & 2-Ch Amplifier with AquaControl Software
Item# ASH-MXA-1502
The Ashly Audio mXa-1502 with AquaControl™ provides total control over four separate zones with a rich compliment of digital signal processing, including routing, auto-mixing, ducking, amplifier monitoring, event scheduling/triggering and more. All through our easy-to-use AquaControl™ that doesn't require a week of tutorials to understand and configure. It lets you and your customers navigate using virtually any browser-enabled device. Trouble-shoot or re-configure it without...
Availability: Usually Ships in 5-14 Days
Item Details
Ashly Audio NE24.24M 8X12 Protea DSP Audio Matrix Processor 8-In x 12-Out
Item# ASH-NE2424M-8X12
Whether you are designing or installing a system for corporate boardrooms, restaurants, courtrooms, houses of worship, left/center/right high output speaker systems in performance spaces, auditoriums or conference centers, our widely-popular Protea ne24.24M Matrix Processor will more than satisfy your requirements for any zoned system. When your install requires input/output matrixing with signal processing it doesn't get much easier than programming your channels using Protea ne Software on your...
Availability: Ships Factory Direct, Typically in 3-10 Business Days
Item Details
Ashly Audio NE8250 8 x 250W @ 4 Ohm Power Amplifier Line Level In/Out
Item# ASH-NE8250
NE Series 8250 Eight-channel, 250W/ch @ 4 ohms, 25V, 70V, 100V Specifications: Output Circuitry: Class D Input Sensitivity: 6.2dBu Frequency Response: 20 Hz - 20 kHz, +/- 1.0 dB Damping Factor: - 8 ohm load, > 250 Input Impedance: 20 k ohms, balanced Maximum Input Level: +21 dBu Cooling: Temperature dependent speed-controlled fan (Front In, Side Out) Front Panel Indicators per channel: Signal: -18, -12, -6,dB, Clip, Temp, Current, Bridge Front Panel Indicators:...
Availability: Ships Factory Direct, Typically in 3-10 Business Days
Item Details
Ashly Audio RW-8C Fader Remote - Hardwires to Ashly Remote-Data-Port - 8-Channel and Master - Wall Mount
Item# ASH-RW-8C
Control your system from any location with our remote controls. The Ashly RW-8C is a hard-wired wall-mounted programmable remote fader controller for Ashly amps and processors that have DSP and a serial data connector. Using Protea NE Software, each fader is assigned to adjust the level of one or more input or output channels or control the DSP matrix mixer. A master fader controls the overall level of all faders.Designed for a standard 4-gang US electrical box and uses a Euroblock connector....
Availability: Ships Factory Direct, Typically in 3-10 Business Days
Item Details
Ashly Audio NE8250.70PED 8-Channel Class-D Network-Enabled Power Amplifier with Dante Option Card
Item# ASH-NE8250-70PED
The Ashly Audio NE8250.70PED is an ne Series, Network Enabled, 8-Channel, Class-D Power Amplifier with the Dante Option Card installed. Designed around an energy efficient Class-D platform with a switching power supply, ne Series amps offer ease of use, setup and control using standard 10/100 Ethernet protocol and Protea™ NE Software. No special outboard control units are needed. Connecting and controlling an amplifier for networked systems has now been simplified with ne...
Availability: Usually Ships in 5-14 Days
Item Details

Ashly Audio

By Category

By Price Range

Filter By

Narrow Products

By Category

By Price Range

Filter By

Ashly Audio 24.24M Output - 4-Output Expansion Module for Protea 24.24M Matrix Processor

Ashly Audio CA-1.54 2RU 4-Channel High Efficiency Power Amplifier - 4x 1500 Watts @ 2/4 Ohms or 70V 750 Watts @ 8 Ohms

Ashly Audio mXa-1502 4-Zone DSP 16x4 Mixer & 2-Ch Amplifier with AquaControl Software

Ashly Audio NE24.24M 8X12 Protea DSP Audio Matrix Processor 8-In x 12-Out

Ashly Audio NE8250 8 x 250W @ 4 Ohm Power Amplifier Line Level In/Out

Ashly Audio RW-8C Fader Remote - Hardwires to Ashly Remote-Data-Port - 8-Channel and Master - Wall Mount

Ashly Audio NE8250.70PED 8-Channel Class-D Network-Enabled Power Amplifier with Dante Option Card

Sign In

Ashly Audio

Narrow Products

By Category

By Price Range

Filter By