-
RF Venue
Item# RFV-DFINBDISTRO4
The DFINBDISTRO4 from RF Venue is a bundled package containing the DISTRO4 4 Channel Antenna Distributor and the Diversity Fin Black install antenna.
The DISTRO4 distributes diversity RF and DC power across four wireless microphone receivers of any brand. A true "distribution amplifier", DISTRO4 splits signals from two antennas (or one Diversity Fin) connected to the rear panel and amplifies them before delivering the signals to...

-
Shure Inc
Item# SH-UA864US
The UA864US antenna provides wideband RF coverage in a low-profile enclosure that mounts easily on a wall or ceiling. Works with ULX-Dr Digital, UHF-Rr, and ULXr Wireless Systems, as well as Axientr Wireless Management Network.
A neutral white housing allows the antenna to blend into corporate or classroom settings, and can be painted to match interior color schemes. The 4-position selectable gain switch provides attenuation and boost settings to optimize the antenna performance for varying transmitter...

-
Shure Inc
Item# SH-UA874
Experience improved wireless reception with the UA874. This UHF antenna uses a log periodic dipole array to produce a cardioid pattern toward the desired coverage area, achieving greater rejection of RF signals outside the area than standard 1/2 wave omnidirectional antennas.
An integrated amplifier with four gain settings compensates for varying degrees of coaxial cable signal loss.
The UA874 can be stand-mounted, suspended from the ceiling, or wall-mounted using the included swivel adapter...

-
DPA Microphones
Item# DPA-DAD6010
The DPA DAD6010 is an adapter that connects the d:fine™ line of headset microphones, the d:screet™ series of miniature microphones as well as the d:vote™ range of instrument microphones to Adapter for Shure, TOA, PGX1 & Line 6 wireless systems. The adapter comes with an original DPA MicroDot to a TA-4F Switchcraft. It is also available as a fixed connector.
Flexible adapter system
The adapters for wireless systems give you flexible, simple and...

-
RTS Intercoms
Item# APS-1
The RTS APS-1 is a 2:1 antenna splitter or combiner. This is a great solution to combine or distribute simple 2-up systems setups of BTR-800 or BTR-700. The APS-1 can be used with any UHF RTS RadioCom base.
Features: Small Size, approximately 2" x 2"
Convenient TNC connectors (No coaxial adapters required)
Signal Loss: -3.5dB, typical
Frequency Range: 100MHz to 900MHz
Low insertion loss, 0.3dB, typical (loss above 3dB)
Good UHF isolation, 26dB, typical
Up to 5W power input...

-
Sennheiser
Item# SENN-EWD-ASA-QRS
The Sennheiser EW-D ASA (Q-R-S) is an active antenna splitter (dual 1:4) with DC power distribution for EW-D receivers. Includes (1) NT 12-35 CS power supply and (8) BNC cable (470-706 MHz) Features: Specifications: Frequency Range: 470-694 MHz

-
DPA Microphones
Item# DPA-DAD6021
The DPA DAD6021 is an adapter that connects the d:fine™ line of headset microphones, the d:screet™ series of miniature microphones as well as the d:vote™ range of instrument microphones to Lectrosonics UHF (low level) wireless systems. The adapter comes with an original DPA MicroDot to TA-5F Switchcraft. It is ideal for normal sound pressure level (0 dB attenuation).
For high-SPL use, the Lectrosonics M185 adapter (with -20 dB attenuation) is recommended.
Flexible...

-
DPA Microphones
Item# DPA-DAD6001-BC
This adapter is active-signal balanced, which improves suppression of induced electromagnetic noise. Common Mode Rejection Ratio (CMRR) is better than 60 dB from 50 Hz to 15 kHz. The adapter is functional at 12 V phantom power but needs 48 V ±4 V to reach full specifications.
The DAD6001-BC adapters for wireless systems give you flexible, simple and affordable possibilities. You are no longer bound to one wireless system. As circumstances change, you can just switch your...

-
RF Venue
Item# RFV-ILAMP-ACT
The RF Venue ILAMP-ACT is an in-line amplifier designed to compensate for RF antenna signal loss on long coax runs.
One ILAMP-ACT provides 10 dB of gain, enough to compensate for 66' of RG-58 cable. For longer runs, up to two in-line amps can be cascaded using either a BNC female to BNC female adapter or a coax jumper cable (both available separately).
The unit can be powered via the antenna power output from an antenna distributor or a receiver, or using the included AC adapter. A...

-
Remote Audio
Item# REM-ANSMA
Remote Audio "Miracle Whip" ANSMA Flexible Antenna Kit. Always straightens! Miracle Whip antennas are made of memory steel which is flexible but highly resistant to permanent bends.
Recommended for Lectrosonics, Zaxcom, or any other UHF Receiver or Transmitter using SMA connectors operating between 500-900 MHz (Lectro Blocks 21-33). Includes frequency trimming chart and color coding bands.

-
Connectronics
Item# SXLM-MPSLK-18IN
The Connectronics XLM-MPSLK series cables are equivalent to the Sennheiser CL100-2 and feature an XLR (male) to locking 3.5mm connector that are wired to the same specs as the CL100-2. The cable was designed to deliver the unbalanced audio output of the camera mount receiver into the XLR audio input jack of a video camera or field mixer.Compatible for use with Sennheiser Evolution series portable receivers to the audio inputs on Beta Cameras, mixers, amplifiers, etc. Features: Specifications:...

-
Shure Inc
Item# UA505
The Shure UA505 Remote Antenna Mounting Bracket Kit lets you mount a 1/2 wave receiver antenna away from the receiver or the equipment rack. This kit includes one mounting bracket, a bulkhead adapter, and bulkhead adapter nut.
Note: Antennas and bracket mounting hardware (screws, washers, and nuts) are not included in this kit.

-
Shure Inc
Item# UA221
The Shure UA221 Antenna Splitter/Combiner Kit includes two adapters that can be used as one-input, two-output or two-input, one-output passive antenna splitter/combiners for UC4, SLX4, ULXS4, ULXP4, U4S, U4D, UR4S and UR4D receivers.
The UA221 Kit lets you split an incoming signal into two outgoing signals or combine two incoming signals into one signal. Each kit includes two UA221 Splitter/Combiners, four coaxial cables, and attaching hardware.
The UA221 Splitter/Combiners are designed for...

-
Sennheiser
Item# SENN-CI1
Sennheiser Instrument 1/4" phone Cable for Wireless Bodypack Transmitter

-
-
Shure Inc
Item# SH-UA8-900-1000
UA8 is a 1/2 wave omnidirectional receiver antenna for UHF-R, ULX, SLX, ULX-D, and BLX4R receivers (frequency range dependent) and PSM transmitters.
Features 0-, 45-, and 90-degree positioning for increased stability.
For frequency range 900-1000 MHz

-
Sennheiser
Item# A1031-U
Wideband passive omnidirectional UHF antenna Sold individually.

-
AKG Acoustics
Item# AKG-MK-HSSTUDIOD
The AKG MK HS Studio D cable is a 3pin XLR male & 1/4" TRS jack interconnector cable for the AKG HSD171 and AKG HSD271 professional closed-back headsets. This detachable cable is suitable for all AKG HSD headsets including their studio, moderator, and commentator headsets. The cable features a 6-pin mini XLR connector on one end that connects to AKG HSD Headsets, and a 6.3mm (1/4") stereo jack and three-pin XLR male on the other end. No phantom powering required. Specifications:...

-
AKG Acoustics
Item# AKG-SRA2-EW
Universal directivity
The AKG SRA2 EW is a passive directional wide-band UHF antenna that can be used as a transmitting or receiving antenna for wireless microphones and in-ear monitoring systems. It operates in a frequency range from 470MHz to 952MHz and provides a covering angle of 70ø and an antenna gain of 6dB. The SRA2 EW is built in a passive technology and requires no powering. It works for short cable lengths up to 10m and supports a professional BNC connector....

-
Sennheiser
Item# AM2
Sennheiser AM2 BNC Connecting Cables for Mounting 2 Antennas on GA2

-
Audio-Technica
Item# AT-ATW-A410P
The Audio-Technica ATW-A410P is a low-profile UHF (470-990 MHz) antenna that mounts to a wall or ceiling. It features a 4-position switchable amplifier (-10 dB/0 dB/+6 dB/+12 dB) to compensate for cable loss, along with an LED indicator to display the current gain setting. To accommodate various installation environments, the antenna's BNC cable can be configured to exit from the top, side or rear of the antenna. Includes mounting bracket and screws.
Features: Low-profile UHF antenna mounts...

Our Price: $349.00
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Audio-Technica
Item# AT-GRCW
The Audio-Technica AT-GRcW guitar input cables feature quality construction and state-of-the-art professional connectors for affordable & reliable performance.
Features: 1/4" right-angle connector to locking 4-pin connector for use between instrument and A-T UniPak body-pack wireless transmitter
Length: 36" (0.9 m)
Specifications:

-
Beyerdynamic
Item# BYD-WA-AS6-2
The Beyerdynamic WA-AS6/2 is a 6-way wideband antenna splitter operating in the frequency range of 470 to 832 MHz. For the diversity operation the WA-AS 6/2 is provided with two identical antenna paths. For each antenna path there are two inputs ("Prim In" and "Sec In") available. Five outputs ("Out 1" to "Out 5") for the connection of receivers or cascades of receivers, as well as one output for looping the signal to other splitters ("Through"). If the "Through" output is not required for...

Our Price: $1,199.00
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Beyerdynamic
Item# BYD-WA-ATDA
The Beyerdynamic active WA-ATDA directional antenna is a receiving antenna for indoor or outdoor use. It has a logarithmic periodic dipole field and provides a better reception and suppression of interfering RF signals from the rear than omnidirectional half-wave antennas due to its lobe polar pattern.
The antenna operates in the UHF range between 470 and 1,000 MHz and can be used with all wireless system with an antenna voltage of 8 to 9 V such as the beyerdynamic series TG 1000. It is...

Our Price: $429.99
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Beyerdynamic
Item# BYD-WA-ATO
The Beyerdynamic WA-ATO omnidirectional antenna is a transmitting and receiving antenna, which is suitable for use inside or outside. The antenna operates in the UHF range from 470 to 790 MHz and can be used with beyerdynamic wireless systems such as TG 1000. It is connected via a BNC socket. The WA-ATO can be mounted on stands (3/8").
For diversity operation, we recommend the use of two WA ATO antennas. Features: Passive transmitting and receiving antenna
470 - 790 MHz
BNC connection Specifications:...

Our Price: $199.99
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List