-
Item# ETS-PV991
The PV991 HD-SDI Splitter is designed to split a SMPTE 292M video signal into two full-quality broadcast video signals and send them over RG59 coax up to 450 feet. The two FBNCs can passively split the signal and send the HD-SDI video signal out the `out' FBNC to video monitors or other digital devices up to 75 feet.* (*based on Belden® cable). Features: Enables two outputs from a single source without interference or impedance mismatching
Passive device offers superior reliability and simplicity-no...

-
Item# ETS-PV992
Energy Transformation Systems does it again. Featuring the ETS PV992 3G SDI 1X2 Splitter. This passive, versatile and easy-to-use video splitter is designed for studio use, on-location productions, as well as live performance venues. The SDI Splitter can be used for monitoring in a wide variety of installations and locations. The small, compact solution can be easily integrated into most sytems easily and discreetly.
The PV991 1x2 3G SDI Splitter supports all standard serial digital video data...

-
Item# ETS-PA202M
The ETS InstaSnake Series (PA200) gives a compact, lightweight, versatile passive group of components allowing you to run audio signals over a single run of CAT5 or 5E or 6 cables. With a roll of wire, these compact units are easily transported and/or stored solving dozens of live and/or recording sound problems. You can mix and match Mic/Line, Line or AES/EBU configurations making the InstaSnake a versatile high quality solution at affordable prices.
The basic units are passive units with bi-directional...

-
Item# ETS-PA830
3 Versions AvailableThe ETS PA830 Series are the Balanced Line™ Digital Audio Splitters and Digital Audio Splitter Panels. These products are expressly designed for the digital audio market. Used only for balanced 110 Ohm signals, these units accommodate signal levels to 10V. Since proper impedance is maintained, the splitters do not have to be symmetrically applied.
Due to careful specification and minimal signal modification, these units may be cascaded reducing transmitted signal power by 3 dB at each stage.
New...
Read More
-
Item# ETS-PA207
ETS PA207 2u 19in Rack Mount Panel w 3 blank plates - holds up to 4 InstaSnakes

-
Item# ETS-AV608
The ETS CAT5 A/V Broadcast System is a UTP Audio/Video Distribution Hub. It has baseband video with two channels of line-level audio transmit through the distribution amplifier, creating 8 out- put sets (video + stereo audio) from a single source. The powered AV608 can be cascaded twice (three tiers), yielding a total distribution of 512 displays from just one input source.
NTSC, PAL, SECAM or CCTV signals are converted to and from UTP using the AV900 or AV901 Baseband Audio/Video Baluns. Alternatively,...

Our Price: $492.30
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-AV822
The ETS AV-822 is a High Definition Component Video + Audio Balun for ease of use and consistent signal labeling in applications that utilize component video signals. Component video formats include RGB, YUV, YIQ and YCrCb.
High Definition Component Video + Digital Audio + Analog Stereo Audio + IR or Data Pass Through is for high-end home and professional theaters that transmits signals from 480p to 1080p resolution video. Features: HDCVB + Stereo Audio, (5) RCA jacks to (2) RJ45 jacks Video:...

Our Price: $154.00
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-AV827
The ETS AV-827 is the only HDTV Over CAT5 Balun on the market that handles digital audio, mono analog audio and stereo analog audio (two Cat5 cables required for stereo analog).
The ETS AV827 is a High Definition Component Video + Digital Audio + Analog Stereo Audio + IR or Data Pass Through. It is designed for ease of use and consistent signal labeling in applications that utilize component video signals. Component video formats include RGB, YUV, YIQ and YCbCr.
YCbCr component...

Our Price: $182.95
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-AV828
The ETS AV828 is a High Definition Component Video + Digital Audio + Analog Stereo Audio + IR or Data Pass Through balun. This balun is designed for ease of use and consistent signal labeling in applications that utilize component video signals.
Component video formats include RGB, YUV, YIQ and YPbPr. Custom labeling is available for use with your application as required (YPbPr shown above). Due to custom labeling requirements, additional lead times may apply for these baluns.
YPbPr...

Our Price: $192.95
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-AV900
5 Versions AvailableBaseband video is the analog signal you get from the "Video Out" connector on a VHS, Camera or other equipment. Usually it's an RCA-style connector, or a BNC on professional-grade devices. The single video plus stereo audio products (AV900 & AV901) are among our most popular products, sending signals over UTP CAT5 or CAT6 cable. There are multi-channel panel devices available here, as well.
Two units required to create a complete system.
Read More
-
Item# ETS-AV900WPIY
5 Options and 2 Colors AvailableThe ETS AV900WP, AV901WP and AV906WP have been redesigned with new flat circuit boards providing Baseband Video/Stereo Wall Plates which are utilized for point-to-point replacement of coaxial (video) and shielded (high impedance audio) cables with UTP wiring, Category 5 or better.
The AV901WP (with 3 RCA jacks for all inputs) is designed for installations that have a need for separate audio channels. For example, some VCRs and Video Cameras have video plus stereo outputs available on three RCA...
Read More
-
Item# ETS-AV970
3 Versions AvailableThe ETS AV970 VGA Video + Stereo Audio Balun Set allows computer video + stereo audio signals that adhere to the VGA/SVGA/XVGA standards to be transmitted over Category 5 or better UTP wiring. All modes and resolutions operate normally.
Distance and quality of transmission are dependent on the type of cable used and monitor sync circuitry. Ordinary UTP cabling may be used, however distance and quality are enhanced with Cat5 or better cable. The circuitry in the AV970 set of VGA...
Read More
Our Price: $186.30
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-EIP75FBNC45
As prices for IP cameras continue to drop and the quality continues to rise, there is an increase in the number of IP camera installations in many types of facilities which already have installed coax. ETS now has a way to utilize the existing coax cable by installing a pair of low cost ETS IP Camera Baluns (EIP-XX Series).a technology unique to ETS.
Using installed coax with ETS IP Camera Baluns can be used as a permanent installation solution or as a stop-gap measure until later upgrades are...

-
Item# ETS-EIP75MBNC45
As prices for IP cameras continue to drop and the quality continues to rise, there is an increase in the number of IP camera installations in many types of facilities which already have installed coax. ETS now has a way to utilize the existing coax cable by installing a pair of low cost ETS IP Camera Baluns (EIP-XX Series).a technology unique to ETS.
Using installed coax with ETS IP Camera Baluns can be used as a permanent installation solution or as a stop-gap measure until later upgrades are...

-
Item# ETS-PA202F
The ETS InstaSnake Series (PA200) gives a compact, lightweight, versatile passive group of components allowing you to run audio signals over a single run of CAT5 or 5E or 6 cables. With a roll of wire, these compact units are easily transported and/or stored solving dozens of live and/or recording sound problems. You can mix and match Mic/Line, Line or AES/EBU configurations making the InstaSnake a versatile high quality solution at affordable prices.
The basic units are passive units with bi-directional...

-
Item# ETS-PA202FP
ETS PA202FP InstaSnake Adapter; Send (4)FXLR 1.50 Ft. Pigtail to RJ45 Jack; All Pins

-
Item# ETS-PA202FRJWP
The ETS InstaSnake Series (PA200) is a compact, lightweight, versatile passive group of components allowing you to run audio signals over a single run of Cat 5, 5e, 6 or 6a data cables. With a roll of cable, these compact units are easily transported and/or stored solving dozens of live and/or recording sound problems.
The InstaSnake is a passive unit, so you do not need power. The InstaSnake accepts mic level or line level analog or digital audio and supports phantom power when using shielded...

Our Price: $142.27
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-PA202FWP
2 Versions AvailableA pair of these US made passive units will send up to four audio signals over a single run of CAT5, 5E or 6 cables. InstaSnake™ has been factory tested to 1900' over CAT5 using low Z dynamic microphones. Phantom powered condenser microphones to 850' over shielded cable. Ideal for hospitality and studio applications where appearance is important.
Read More
Our Price: $142.27
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-PA202MRJWP
The ETS InstaSnake Series (PA200) is a compact, lightweight, versatile passive group of components allowing you to run audio signals over a single run of Cat 5, 5e, 6 or 6a data cables. With a roll of cable, these compact units are easily transported and/or stored solving dozens of live and/or recording sound problems.
The InstaSnake is a passive unit, so you do not need power. The InstaSnake accepts mic level or line level analog or digital audio and supports phantom power when using shielded...

Our Price: $142.27
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-PA202P
The ETS InstaSnake Series (PA200) is a compact, lightweight, versatile passive group of components allowing you to run audio signals over a single run of CAT5, 5E or 6 cables. With a roll of wire, these compact units are easily transported and/or stored solving dozens of live and/or recording sound problems.
The InstaSnake is a passive unit, so you do not need power. The InstaSnake accepts "mic" level, analog or digital audio and supports phantom power when using shielded Cat5 or 6 cables.
TheThe...

-
Item# ETS-PA203F
3 Versions AvailableThe ETS InstaSnake PA203 Series is configured for 3 sends and 1 return. Each passive send unit (PA203F) features 3 Female XLR and 1 Male XLR to RJ45 jack, all pins. Each passive receive unit (PA203M) features 3 Male XLR and 1 Female XLR to RJ45 jack, all pins. The ETS-PA203P adds the convenience or an 18" XLR Pigtail at the receive end.
The basic units are a pair of passive units with bi-directional capability which can be input...
Read More
Our Price: $157.20
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-PA203FP
The ETS InstaSnake™ Series (PA200) is a compact, lightweight, versatile passive group of components allowing you to run audio signals over a single run of Cat 5, 5e, 6 or 6a data cables. With a roll of cable, these compact units are easily transported and/or stored solving dozens of live and/or recording sound problems. Designed to the highest professional standards the InstaSnake™ has a wide, flat frequency response, low THD and residual noise. The InstaSnake™ has been factory...

-
Item# ETS-PA204M
The ETS InstaSnake PA204M is a passive network audio snake featuring two male XLR sends, two female XLR returns, and one RJ45 ethernet jack. The PA204M allows you to run audio signals over a single run of CAT5, 5e, 6 or 6a data cables.
The passive InstaSnake doesn't need power, and it accepts mic or line level analog or digital audio, supports phantom power when using shielded CAT5 or 6 cables. The unit also features bi-directional capability which can input directly into analog or digital...

-
Item# ETS-PA205F
The ETS InstaSnake PA200 Series is configured for 3 sends and 1 return. Each passive send unit (PA205F) features 3 Female XLR and 1 Male XLR to RJ45 jack, all pins. Each passive receive unit (PA205M) features 3 Male XLR and 1 Female XLR to RJ45 jack, all pins. The PA205 will send phantom power over standard Cat5 or 6 cables. Phantom power has been tested to 850 feet over shielded cable.
The basic units are a pair of passive units with bi-directional capability which can be input directly into...

Our Price: $150.40
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List
-
Item# ETS-PA205M
The ETS InstaSnake PA200 Series is configured for 3 sends and 1 return. Each passive send unit (PA205F) features 3 Female XLR and 1 Male XLR to RJ45 jack, all pins. Each passive receive unit (PA205M) features 3 Male XLR and 1 Female XLR to RJ45 jack, all pins. The PA205 will send phantom power over standard Cat5 or 6 cables. Phantom power has been tested to 850 feet over shielded cable. The basic units are a pair of passive units with bi-directional capability which can be input directly into...

Our Price: $150.40
Availability: Direct Ship from manufacturer, contact us for availability
Add to Wish List